Categories
Ask Engineering

Determining width and length from CMOS inverter layout

How do I determine the width and length from the following cmos inverter layout, given that lambda=0.25um? The answer is Wn=1.0um, Ln=0.25um, Wp=0.5um, and Lp=0.25um. I know that the length is equal to 2 x lambda, but I do not understand how to get width from the layout.

Categories
Ask Engineering

Determining width and length from CMOS inverter layout

How do I determine the width and length from the following cmos inverter layout, given that lambda=0.25um? The answer is Wn=1.0um, Ln=0.25um, Wp=0.5um, and Lp=0.25um. I know that the length is equal to 2 x lambda, but I do not understand how to get width from the layout.

Categories
Ask Engineering

Can I connect a PSU to the Ramps 1.6+ and the USB to Arduino at the same time?

I just want to connect the Ramps to the power supply unit and upload the Marlin firmware to the Arduino. I found three possible outcomes 1. Problem I found one person here who says that we should not use external power for the Ramps and plug the USB to the Arduino at the same time […]

Categories
Ask Engineering

What does “2 digit BCD number” mean?

When I read it, I think a 2 digit BCD number is something between 0 and 99 in decimal. So, for example, 0100 1001 is a 2 digit BCD number and decimal equivalent of it is 49 in my opinion. However, this question confused me. I want to interpret A_0 or A_1 as a 4 […]

Categories
Ask Engineering

What does “2 digit BCD number” mean?

When I read it, I think a 2 digit BCD number is something between 0 and 99 in decimal. So, for example, 0100 1001 is a 2 digit BCD number and decimal equivalent of it is 49 in my opinion. However, this question confused me. I want to interpret A_0 or A_1 as a 4 […]

Categories
Ask Engineering

What does “2 digit BCD number” mean?

When I read it, I think a 2 digit BCD number is something between 0 and 99 in decimal. So, for example, 0100 1001 is a 2 digit BCD number and decimal equivalent of it is 49 in my opinion. However, this question confused me. I want to interpret A_0 or A_1 as a 4 […]

Categories
Ask Engineering

How To Play Music On PAM8610 With Esp32?

i’m trying to use xtronical’s DAC audio library on an esp32 to run 10W speakers. The board that xtronical used is a PAM8403 which has a signal voltage range of -0.3V to +0.3V but as it can only run 3W speakers thus i cannot use it. Hence, i am using a PAM8610 which can drive […]